Super Strong Smco Arc Magnet SmCo5 High Plasticity Cobalt Samarium
Produced by the first rate manufacturer SmCo magnet with good
quality and high performance
Brief introduction of CJ Company Industry
Shanghai CJ Magnet Industry Co.Ltd was established in 2002. There
are 2 factories which both belong to our own company. We
permanently devote ourselves to the production and application of
Sintered NdFeB and Ferrite Permanent magnet. The annual output of
Sintered NdFeB is 1500Ton, Ferrite is 6000Ton and AlNiCo is 600Ton.
Why choose us?
- Our CJ Magnet Industry has focused on the producing of Neodymium
for more than ten years.
- We have imported advanced equipment from Japan and Germany to
update our products in order to satisfy our customs.
- We have a team with high efficiency and high responsibility. We
have the access to the cheapest raw material, so we can reduce your
- Therefore, it is wise of you to choose our company, and we will
provide you with the first rate service. Just believe us!
Culture of OUR CJ Magnet Company Industry
The Vision: To be the professional supplier of magnet, magnetic systems and
The Mission: To be efficient, to be energy-saving, to be eco-friendly--for a
The Management belief: We continuously improve technologies, products, and customers’
experience. We share all values with all of you.
Conduct code: Take ownership
Challenge and improve all we do
Trust Act as a team Be honest
- Cooperate with CAS Institute of Physics and China Jiliang
University ( Hereafter CJLU) .
- http://www.cas.cn/ http://www.cjlu.edu.cn
- An R&D team with 13 professional staff, 3 senior engineers, 5
- Found China Jiliang University Sheensen R&D center in our
plant, with advanced R&D equipment, such as Particle size
analysis , Angler deviation tester , ICP , Hast Tester etc from
Germany and Japan.
Q & A
1. Q When can I get my product after I pay you?
A If we receive your payment,e will send you your product within
half a month.
2. Q If your company didn’t provide us with products of the right
size or performance, can we return you your products?
A Our company will take responsibility if the faults falls on our
company. We have confidence in our team and our company, so if you
provide us with wrong information, we will not take the
3. Q I want to buy products with special shapes, can you produce
A Of course, we design and produce mould, so, if you have any
special needs, just tell us.